Automotive glass generally cannot meet the daily needs of heat insulation and UV insulation. For better heat insulation, UV protection, and safe and healthy driving, it is necessary to apply a film to the car. The car foil is attached to the inside of the car glass, because it is not exposed to wind and rain on the inside, and the aging will be slower, thus extending the service life. Do not lift the window at will within 3 days in the summer and 7 days in the winter after the car is filmed. Here are some more precautions for car foils. Let's take a look.
Car foil precautions
1. After the front shield is attached to the Wrigley film, it should be sun-dried as far as possible during the daytime parking, which will make the front diaphragm dry faster. It usually takes about half a month to dry out completely, including the back gear.
2. After the car has been attached to the car noise insulation film, it is necessary to avoid lifting the window within three days. Because the window glass and the film just after the film is filled with moisture, the window glass is likely to cause the edge of the film to fall off, which seriously prevents the film from being reattached to the glass.
3. Do not wash the car within three days. Due to the high water pressure of professional car wash equipment, water is easily infiltrated from the edge of the window, which will cause the water content of the edge part of the glass and film to be large. It will easily cause the edge of the Wrigley car film to fall off after lifting the window three days later.
4. Vehicles with skylights within three days are not driving, especially during high-speed driving. Because the air inside and outside the car will convect after the sunroof is opened, it is easy to cause the upper edge of the front film to fall off.
5. If there is foaming at the edge of Wrigley's automobile film, it should be repaired at the construction site within 24 hours. After the time is over, the glue around the bubble has dried up, the surrounding of the car film can not move, and the crease will be generated during processing. .
6. Disable the strong adhesive label directly on the film within one month after the film is applied, so as to avoid partial peeling of the film from the glass.
7. After the film is applied in winter, it is recommended that you do not lift the window or wash the car within one week.